Introduction to waterborne wood paint are anticorrosive wood coating construction procedure waterborne wood paint are _ | opal chemical water-based paint
by：Opal
2021-01-18
Now many families of the balcony or terrace, choose to use anticorrosive wood floor.
So, in decorating a how to brush anticorrosive wood wood coatings?
Underneath, small make up to you some about anticorrosive wood besmear to brush the construction procedure of waterborne wood coatings.
1, anticorrosive wood stacked, each layer has a 10 - must do 12 mm gap, but also to prevent the rain or sun direct illuminate.
2, want to use the size of the anticorrosive wood may, for cutting, drilling, etc. , must use the preservative coating remedy to ensure the integrity of the coating.
3, at the time of connection should be drilling in advance, in order to reduce cracking.
4, all connections must use hot dip galvanized fasteners, or stainless steel hardware, to prevent corrosion.
5, build terraces and road use long wooden board as far as possible to reduce joint, in order to beautiful. Board face between 3 - shall be maintained 7 mm gap.
6, anticorrosive wood type used in the adhesive should be waterproof, weather resistance.
7, outdoor construction is completed, should do well in maintenance, such as brushing waterborne wood coatings, Outdoor wood paint) Etc. , avoid the weathered, bring about lumber cracking and deformation.
8, if besmear brushs waterborne wood coatings, be sure to choose better weatherability, outdoor wood paint, and wet wood surface is unfavorable for the construction.
9, thickness is greater than 35 mm wood square, to prevent the deformation, can be in the center of the wood core side, open a width and depth are about 10 mm small slot
10, the use of different environment ( Such as on the ground, or under the water) , should use different grades of anticorrosive wood, to ensure that meet the design life.
1, anticorrosive wood stacked, each layer has a 10 - must do 12 mm gap, but also to prevent the rain or sun direct illuminate.
2, want to use the size of the anticorrosive wood may, for cutting, drilling, etc. , must use the preservative coating remedy to ensure the integrity of the coating.
3, at the time of connection should be drilling in advance, in order to reduce cracking.
4, all connections must use hot dip galvanized fasteners, or stainless steel hardware, to prevent corrosion.
5, build terraces and road use long wooden board as far as possible to reduce joint, in order to beautiful. Board face between 3 - shall be maintained 7 mm gap.
6, anticorrosive wood type used in the adhesive should be waterproof, weather resistance.
7, outdoor construction is completed, should do well in maintenance, such as brushing waterborne wood coatings, Outdoor wood paint) Etc. , avoid the weathered, bring about lumber cracking and deformation.
8, if besmear brushs waterborne wood coatings, be sure to choose better weatherability, outdoor wood paint, and wet wood surface is unfavorable for the construction.
9, thickness is greater than 35 mm wood square, to prevent the deformation, can be in the center of the wood core side, open a width and depth are about 10 mm small slot
10, the use of different environment ( Such as on the ground, or under the water) , should use different grades of anticorrosive wood, to ensure that meet the design life.
