Water bag, water bag sand multi-color 'frame line' construction main point total is

The construction gist is generally 'frame line' ( 1) Increasing the intensity of be bored with child, 'putty flushing and maintenance' must be in place for at least 2 times; ( 2) After black paint dry, should be at least 24 hours after the construction of masking paper paste protection. ( 3) After completion of intermediate coating, should be timely off laid paper, intermediate coating finish off after 30 minutes at room temperature laid paper; ( 4) Suggested that the construction use masking paper quality; ( 5) Construction of the grid lines calculation should master of science (as far as possible Suitable for square grid or i-section grid) 。 ( 1) Grid shape in order to make the wall effect is not stiff, try not to choose the square grid construction in painting, such as horizontal grid, vertical long grid and 'I' word is right choice. However, consideration should be given to the use function of the building. For example, a business unit office building should choose a more sedate partition design, and residential buildings, shopping malls, school, stadium, etc can choose a more lively zoning plan. ( 2) Grid position in order to make the color paint spraying effect is closer to the stone material, in principle, you can use the same as the stone of the grid, such as Yin and Yang Angle of the grid, the window edge mesh grid and floor. However, given the limitations of stone material, can be separated in the Angle of Yin and Yang is not under the situation of the water sand separator. Suggestions on the side of the window segmentation, pay attention to avoid even the appearance of the edge of the small and small. ( 3) The size of the grid should be according to the height of the building reasonable division. In general, high-rise building grid should be 1. 5 - 2 ㎡, multi-storey building grid should be controlled in 1 - 1. 5 ㎡, low-rise buildings of the grid should be within 1 ㎡. ( 4) The width of the frame the width of the seam frame joint must be designed according to the size of the frame size is reasonable. General should be 0. 8 - 1. Between 5 °, also can design for horizontal width, width of the vertical and horizontal width of the frame, but the width of the frame joints should be controlled within 2 °.