Water bag water spray gun several skills! ！ ！ ！ ！ ！

Water bag has become the mainstream of exterior wall coating products, colorful coating under construction problem has become the focus of attention. On the basis of how to improve the efficiency of the best water bag outside wall effect, is water bag construction personnel issue of concern. Here are some use the technique of water bag water spray gun. 1. Water bag water spray gun movement speed bag colorful coating is the adornment effect of is what? Water bag water construction technology is the key part, gun movement speed is the key. 1) If in the process of water package of water spray, spray gun movement speed is too high, water bag water surface coatings will become thin, thin coating effect can appear, not full, not beautiful, does not show up. 2) If the spray gun movement speed too slow, coating is too thick, lead to sagging. 3) Water bag water spray gun movement speed should make full spray coating, uniform, moist. Only have certain experience in construction personnel can achieve the effect. 2. Control of water bag water spray gun trigger, the trigger is used to control the flow of injection lance. Pull the trigger the deeper, the greater the flow velocity of water bag water paint. When moving electrostatic spraying equipment, the trigger is dead, but 'not deducted half'. In order to avoid coating spray gun to walk at the end of the accumulation, generally experienced construction personnel slightly loosen the trigger to reduce feed rate. 3. Alignment position when spraying water bag water spray gun, spray gun and metope should try to keep the vertical or in a vertical state, because if the gun skew, spraying with the migration, the paint will flow to the side. The other half without paint, very thin and even have stripes. 4. Spray gun in general, the distance to the wall of water package of water spray gun best spraying distance between 30 cm to 40 cm. If the spray gun, get too close to the walls may result in coating. If the distance is too far away, it is easy to cause dry coating or coating, this will make the coating less popularity. 5. Water bag water gun position gun is controlled by the hand and fingers. Usually, palm, thumb, ring finger and little finger holding the gun, middle finger and index finger to pull the trigger. In practice, many construction personnel will from time to time, change the way of holding a gun in the long-term work, only the thumb, ring finger or little finger holding a gun, with middle finger and index finger to pull the trigger. The spray can greatly reduce fatigue, improve work efficiency.