Speak with authority, quality is trustworthy.

Be careful, autumn is dry, your furniture will 'lose'

by:Opal     2021-01-18
Autumn is dry, everyone worry about home furniture fire didn't at the meeting, especially wooden furniture, including the floor, due to the special material, cranking in season, is to fire service object.






a, floor cracks increase


root cause analysis: after the autumn, the weather becomes dry, greatly reduce the air humidity, real wood floor will appear shrinkage phenomenon, lead to the floor cracks. Merchants spring delayed the year maintenance, also have a point. In winter, real wood floor contraction could be exacerbated.






the solution: autumn repair should pay attention to don't try so hard, the spring of next year, the four seasons temperature difference obvious change, real wood floor cracking and deformation problems no longer development later, and then to one-time repair. To ensure better leave out the trouble that repeatedly repair again at the same time.






special remind: autumn comes, the real wood floor waxing right maintenance. Wipe clean the floor before waxing, and apply evenly on the surface layer of floor wax, slightly dry with a soft cloth to wipe, until smooth, shiny. As far as possible should open a window ventilated, maintain the room air circulation. In a period of time, after the weather is getting dry, need to use a humidifier to adjust the indoor humidity.






2, solid wood furniture, lose luster


root cause analysis: solid wood furniture surface coated with acrylic paint, the paint film of the maintenance and maintenance is particularly important, paint film once destroyed not only effect the beauty of the surface, and will further affect the internal structure of products. Poor maintenance can lead to real wood furniture loses luster, autumn or cracking phenomenon.






the solution: should maintain the cleanness of solid wood furniture, often on a daily basis with pure cotton dry soft cloth gently wipe the surface dust, two or three days with a damp cloth to wipe. Solid wood furniture surface stains, if any, never tried hard to clean, available temperature tea remove stain gently.






special remind: actually, appropriate use of thin plastic separates solid wood furniture from the ground contact area, at the same time keep solid wood furniture parts against the wall with wall 0. 5 - 1 cm distance gap. Avoid too damp environment, so as not to decompose solid wood furniture.






3, door frames do cracking


root cause analysis: unless it is of good quality and very thick wood line, otherwise, to install the door directly with thin wooden line is not sturdiness, reason is that the physical properties of different materials, so the door is not easy to contact with the wall stability. In addition, the thickness is not enough wood line will also when in contact with wall cracking and deformation.






the solution: you can use glue to fill the door crack, and then use paint to repair the door covers the original color. If the door material is too thin, it is better to ask workers to rework.






special remind: autumn comes, the real wood floor waxing right maintenance. Wipe clean the floor before waxing, and apply evenly on the surface layer of floor wax, slightly dry with a soft cloth to wipe, until smooth, shiny. As far as possible should open a window ventilated, maintain the room air circulation.






4, seamless tiles broke off


root cause analysis: due to the base layer, adhesive layer and the heat bilges cold shrink coefficient of ceramic tile itself difference is very big, in 1 ~ 2 years of tension damage under hot cold, too close up of the ceramic tile to summon up, fracture and so on. If appear this kind of problem for large scale after the shop is stuck, the cost will be two or three times more expensive than the first time the shop is stuck.






the solution: will fall off the back of the ceramic tile to remove silt, and blended with cement and glue paste. It is important to note that if the tile is only partial loss, don't knock hard on the base layer of mortar, the original shock loose around the ceramic tile of strong.






special remind: joint can be adjusted between 2 ~ 3 mm. At the same time to avoid waste of material, can be random sampling number of selected products first try not glue spread on the ground. If found to have clear off color, size deviation, etc. , in the brick a adjusted still didn't get satisfied effect, it shall timely stop laying, and materials business contact and exchange.






5, shower room explosion danger


root cause analysis: glass shower room interior is a closed space, high temperature and high pressure accumulation to a certain extent on the glass formation pressure, lead to the glass balance, an explosion.






the solution: transparent glass top quality safety explosion-proof membrane, the strength of glass can be increased more than 6 times, though still burst, through the role of the viscous force explosion-proof membrane of the explosive glass pieces glued together, can prevent glass splinters caused by glass explosive injury.






special remind: although toughened glass strength is higher, but the characteristics of toughened glass is that it is more afraid than ordinary glass sharp objects, and fixed, shower room wall will affect the safety of toughened glass, if it is caused extremely easily by the collision explosion as a whole.






the maintenance of household is a deep lesson, every season there are need to pay attention to matters, autumn home fire prevention maintenance is the key, and forward your concern!
Chat Online
Chat Online
Chat Online inputting...
Sign in with: