How water bag water coating material construction?

In the construction of water package of water type coating should do something to reduce the paint loss and cost savings? I believe it was the subject of many consumers care about. This article introduces six ways to save water paint dosage, can be directly applied to the construction of water-based coating, and can save a lot cost effectively. 1, the old wall foundation treatment wall before construction, must remove all the dust and foreign bodies on the wall. All the crack and spalling areas must be filled. At the same time, the wall must be free of saline, oily substances and dragon ridge. At the beginning of construction, must block adjacent walls, in order to avoid spraying coating. Otherwise, dust and foreign bodies of the old walls, common problems, such as crack, flake will brush off directly, without processing, affect the brush, the net effect will cause unnecessary loss, affect the overall coating effect. 2, basal solid processing for old metope, in addition to clean up the base of foundation, also make sure that gives the firm. This is the key to prevent foundation weak factors. This suggests that the construction must be carried out before the strict processing. In the process of inspection, metope can use soda water to clean, wash, and then use putty leveling, it can effectively reinforce the metope at the grass-roots level. 3 if you want to save water paint, construction mode, you must study hard construction method. Spray gun spraying method can guarantee the smoothness of metope, but you have to remember that some do not need to spray the metope of must cover in advance. 4, the rational use of nozzle when selecting nozzle to pay special attention to the type of nozzle, because different nozzle water bag water coating damage. If you choose the spray nozzle width is small, water bag water coating in the construction process of loss will be relatively low, different brands of nozzle spray effect will be different, losses would have been different. Therefore, you should choose regular brands and businesses to buy a product, you can't lose a lot because of the small losses. 5, control the temperature of building coating engineering construction is suitable for construction in 5 - temperature Between 40 ℃ and humidity should be kept below 80%. Thus, spring, summer and autumn is consistent with project relative three seasons. If need to spray in the construction, should pay special attention to the spray within 6 m/s wind speed control, and adjust the air compressor gas pressure in the 60 more than Newton. Six, completes the construction plans, construction personnel should be concrete construction plan ahead of schedule, make sure to confirm the construction time, blind pursuit of speed, avoid using water bag construction personnel for time reasons coating for the phenomenon of completed as soon as possible, also can guarantee the engineering quality. Therefore, the construction can't eager to seek speed. If you need to buy water bag water coating, construction personnel must be notified in advance, to determine the required number of water bag water paint, avoid buying too much water bag water coating cause unnecessary waste.