True stone QiChang home: metope besmear brushs problem. What should I do

Bubbles on metope, crack and spalling is consumer reflect a lot of problems. Shortly after the decoration, the metope of the house or end face began to blister, cracking and peeling. What are the reasons? Division of professional personage points out, in general, use high quality coatings, metope can use normally five to eight years. A short time, blistering, cracking, peeling problems such as abnormal, some of the reasons for these problems, should according to the actual situation for analysis. Really stone paint manufacturers KeBao warns customer, when watching the adornment of metope paint, should grasp the drawing details. The small series to introduce you to the details of the need to master in the process of wall surface coating and metope after coating methods of dealing with the common problems. Metope preparation: before formal wall coating of related preparation work before is very important. First, decide the overall decoration color and high quality green wall paint is very important. After careful selection wall paint, don't think can immediately wall paint. In order to obtain high quality coating, before painting to be prepared for a series of metope is absolutely necessary. This is called a surface treatment before, it has great influence on the quality of the coating. Be bored with child: best choice grain fineness high, a hard putty. Be bored with child can also add a certain amount of white latex, in order to improve the hardness of the putty. Polishing: try to use thinner sandpaper, for soft putty generally use 400 - 500 mesh sandpaper, hard to be bored with child generally use 360 - 400 mesh sandpaper. If rough sandpaper, sand will leave a deep mark, the paint cannot cover. After polishing, metope must be thoroughly clean, in order to prevent too much dust, paint adhesion.